Fastener Torque Chart

Fastener Torque Chart. M12 x 1.25 pitch 8.8 96.0 87.0 72.00 65.25. Each sheet has data printed both sides with laminated protection 8.5”x11” (215.90mm x 279.40mm).

Torque Charts Industrial Bolting and Torque Tools from www.bustinyournuts.com

D) after torquing is completed, draw a straight line (match mark) from the wall of the fastener head onto the seating surface using a white steel paint pen. M12 x 1.50 pitch 8.8 92.0 83.0 69.00 62.25. Fastener and torque chart << click to display table of contents >>click to display table of contents >> navigation:

M12 X 1.75 Pitch 8.8 87.0 79.0 65.25 59.25.

Aft fasteners is your trusted source for fastener information. Torque wrench to be reset to smallest value after operation! Fastener torq ue cha rts.

Currently Only Available In Us Stores Or Internationally Via Online.

The torque applied to a fastener is absorbed in three main areas. M14 x 2.00 pitch 8.8 140.0 125.0 105.00 93.75. For longer fasteners the torque is reduced significantly.

Under/Over Tightening Of Fasteners Can Result In Costly Equipment Failure Or Personal Injury.

M12 x 1.50 pitch 8.8 92.0 83.0 69.00 62.25. Make sure to select the Each bolt grade has an ideal tightening torque for maximum clamping force without breaking.

The Data Provided Should Be Used As A Guide, But Actual Material Strengths And Fastener Conditions May Vary.

Fastener and torque chart << click to display table of contents >>click to display table of contents >> navigation: M12 x 1.25 pitch 8.8 96.0 87.0 72.00 65.25. The following design resources are for design screws and bolts for the proper torque, stress, strain, preload and other engineering critical design parameters.

All Other Torque Values Are In Foot Lb.

In many cases the pattern will be symmetrical, as shown in figure 28. Torque, chart, guide, fasteners, fastening, martin. All calculations are for coarse thread series (unc).

Leave a Comment