Link Seal Chart

Link Seal Chart. 1.center the pipe, cable or conduit in wall opening or casing. Typical specification 1.0 penetration seals.

DepEd Tarlac Official Website from www.depedtarlac.com.ph

1.center the pipe, cable or conduit in wall opening or casing. 0.48 in 0.61 in 0.69 in 0.81 in 0.88 in 1.24 in 1.38 in 1.43 in 1.06 in 1.56 in 2.25 in 2.06 in 1.81 in. Link seal is used to seal the gaps between piping and the wall, floor or ceiling that it travels through.

They Fit Between The I.d.

Check to make sure pipe is supported properly during backfill operations. Link seals work with a range of piping, typically ranging from ½ up through 48 inches. Install the belt with the pressure plates evenly spaced.

This Updated Method Benefits The Engineer, Owner And Contractor.

The annular space is calculated as follows: The annular space is half the difference between your pipe size and the wall opening diameter. Link seal is used to seal the gaps between piping and the wall, floor or ceiling that it travels through.

1.Center The Pipe, Cable Or Conduit In Wall Opening Or Casing.

Of the casing pipe and the o.d. See il sizing specifications on chart below. Matches the actual outside diameter shown on the chart.

Verify That Your Pipe O.d.

Link seal is manufactured with high quality materials to ensure protection in the harshest environments. The annular space is calculated as follows: Matches the actual outside diameter shown on the chart.

Manual And Our Selection Guide.

Use a mechanical seal, consisting of rubber links shaped to continuously fill the annular space between the pipe and the wall opening. Make sure pipe is centered. See the manufacturer sizing chart for specific product type:

Leave a Comment