Stainless Steel Bolt Torque Chart

Stainless Steel Bolt Torque Chart. The following torque values are suggested maximums based upon actual lab testing on clean and dry or near dry fasteners. Clampload is only a estimated number, there maybe situations where the engineer calls for the bolts to be tensioned to a different value.

7+ Sample Bolt Torque Charts Sample Templates from www.sampletemplates.com

Tightening torques for stainless steel bolts. Clampload is only a estimated number, there maybe situations where the engineer calls for the bolts to be tensioned to a different value. Tightening torque (nm) property class min breaking torque;

Suggested Assembly Torque Values The Tapped Hole Or Nut Must Have An Equal Or Greater Proof Load Than The Stud's Minimum Ultimate Tensile Strength.

If you have any further questions or queries please do not hesitate to get in touch. While all care has been taken with its preparation, no responsibility is accepted for the absolute accuracy of the data provided. That will help to pick the right material.

Tightening Torque (Nm) Property Class Min Breaking Torque;

The specification adapts to minimum tensile strength bolt and nuts. Recommended bolt torque values for stainless steel and nonferrous fasteners (inch series). This shows torque values in nm for property classes 50, 70 and 80 as shown in the table below.

Bolting Torque To Develop 50% Bolt Yield Stress At Nut Factor, K=0.16.

The above table is applicable only for astm a320 grade l7, a193 grade b7 and a193 grade b16 stud bolts. The values are based on fasteners that are dry—free of any lubricant—and wiped clean of chips and foreign matter. 316l stainless steel fasteners are used for their low carbon nature with corrosion resistance to sea water.

Clampload Is Only A Estimated Number, There Maybe Situations Where The Engineer Calls For The Bolts To Be Tensioned To A Different Value.

Tightening torques for stainless steel bolts. The primary reason we have decided to omit stainless fastener specifications from our torque chart is because we are unable to. Stainless steel stud bolt and nut size chart | ss stud bolt | ss stud bolt m10 m12 m14 m16 m18 m20 m22 m24 m27 m30 m33 m36 m39 size

Surface Condition Torque Adjustment Factors Plain Steel, As Supplied X 1.0 Plain Steel, Degreased X 2.0 Zinc Plated, As Supplied X 1.0 Zinc Plated, Lightly Oiled X 0.9 Galvanised, Degreased X 2.1 Galvanised, Lightly Oiled X 1.1 Heavily Greased X 0.7 Recommended Assembly Torques Class 10.9 Iso Metric Coarse Pitch Bolts & Screws Bolt Tension.

The chart below offers some suggested maximum torque values for stainless steel fasteners. The following torque values are suggested maximums based upon actual lab testing on clean and dry or near dry fasteners. Uns s31603 bolts, nuts, studs and hex head screws manufacturer, check din 1.4404 bolts torque chart here.

Leave a Comment